Convert to EPIC™ Tape Roll Components

Summary: Learn how to convert your Hunter Douglas horizontal blind to use updated EPIC™ tape roll components. This repair helps if your blind feels stuck, lifts unevenly, or no longer raises smoothly. The instructions apply to blinds with bead-type or slot-type tape roll systems—check for a metal grommet or cord slot inside the headrail to confirm. Converting to EPIC™ ensures better lift performance and long-term reliability.

Applies To: Parkland®, Everwood®, Modern Precious Metals®

Conversion Steps

1. Prepare the Blind
2. Remove the Existing Tape Rolls and Supports
3. Install the EPIC™ Tape Roll Supports
4. Thread the Lift Cords
5. Add the New EPIC™ Tape Rolls
6. Reassemble the Shade

Note: If your shade already uses decorative tapes and you are only replacing worn components, see: Replace Decorative Tape Roll.

1. Prepare the Blind

• Stack the blind under the headrail by pulling the lift cords.
• Remove the valance (if installed).
• Remove the blind from the mounting brackets.
• Tap out the thin metal end lock using a flathead screwdriver and hammer.
• Pull the tilt rod out of the headrail and set it aside.

2. Remove the Existing Tape Rolls and Supports

For Bead-Type Rolls:

• Turn the tape roll upside down to locate the crimped grommet.
• Use needle nose pliers to pull the cord out of the narrow slot.
• Repeat for all tape rolls.

For Slot-Type Rolls:

• Pull the cord and grommet out of the channel by hand.
• Repeat for all tape rolls.

Then:

• Separate the breakaway tassel to detach the lift cord. Save all parts.
• Pull the lift cord down through the old tape roll support.
• Use a flathead screwdriver or flex the headrail to remove the old support.
• Repeat for each support.

3. Install the EPIC™ Tape Roll Supports

• Angle the support toward the rear of the headrail.
• Slide the small tab under the headrail lip.
• Press down to snap it into place.
• Repeat for all tape roll positions.

4. Thread the Lift Cords

• Pull the lift cord down through each new EPIC™ support.
• Route the cord properly using your shade’s configuration.
• Reattach the breakaway tassels.

5. Add the New EPIC™ Tape Rolls

• Insert one pin into the end of the EPIC™ tape roll.
• Push the lift tape through the route hole.
• Squeeze and insert the second pin on the opposite side.
• Snap the tape roll into the support.
• Repeat for all rolls.

6. Reassemble the Shade

• Slide the tilt rod back through the new tape rolls.
• Align the V-notch in the rod with the notch inside each roll.
• Replace the metal end cap.
• Reinstall the blind in the mounting brackets.